A gift as precise as the work.
The one design element that is often missing in avocational woodworking is texture. When done well, texture creates visual interest through repetitive patterns and/or shadows. The HP-10 Large Texture V-Groove irons allow you to add visual interest to boxes, drawer fronts, table legs and the list goes on. One fun use is to texture an edge of a long board and cut this off the parent stock. This strip can then be cross cut into smaller pieces allowing you to make wooden tiles that can be used for decorative elements in boxes and motifs for furniture. Its fast, fun and cannot be easily replicated with a router.
These two texture profiles also allow you to make finger joint glue joints. This is particularly useful when edge gluing thin panels where you want the faces to be aligned perfectly for minimal cleanup.
To sharpen any of the irons, all you need to do is hone the bevel surface at 30 degrees, no special hones required.
Using the HP-10 “V” Groove Profile requires the use of a fence or guiding board clamped to your stock. We recommend using the HP-10 Guide Fence when your cuts are less than 3" from the edge of your stock. If you have a need for a "V" groove that exceeds the capacity of the fence system you will need to clamp a guide in place. The side of the HP-10 body will ride against this reference and your cuts will be as straight as your reference edge.
There are two ways to control depth of cut, one can use the HP-10 Depth Skids (that came with your HP-10 Dado Kit "Works) or by fastening shims to the sole (using double stick tape).
This item is no longer in production and is not available for purchase. It is listed here for reference purposes only. The last known published price is listed below.