HP-10 90 Degree V-Groove Profile

The coolest use for the HP-10 90 Degree V-Groove Profile is to inlay corner moldings into planar surfaces to add contrast and/or texture. It’s fast, fun, and as always, when done well, adds much interest. 

Using the “V” Groove Profile requires the use of a fence or guiding board clamped to your stock if the distances exceeds the fence capacity for dead straight cuts. We recommend using the HP-10 Guide Fence when your cuts are less than 3" from the edge of your stock. If you have a need for a "V" groove that exceeds the capacity of the fence system you will need to clamp a guide in place. The side of the HP-10 body will ride against this reference and your cuts will be as straight as your reference edge.

To sharpen any of the irons, all you need to do is hone the bevel surface at 30 degrees, no special hones required.

There are two ways to control depth of cut, one can use the HP-10 Depth Skids (that came with your HP-10 Dado Kit "Works) or by fastening shims to the sole (using double stick tape).

Customer Reviews

Read Reviews | Write a review

This item is no longer in production and is not available for purchase. It is listed here for reference purposes only. The last known published price is listed below.

Regular price $198.00

The coolest use for the HP-10 90 Degree V-Groove Profile is to inlay corner moldings into planar surfaces to add contrast and/or texture. It’s fast, fun, and as always, when done well, adds much interest. 

Using the “V” Groove Profile requires the use of a fence or guiding board clamped to your stock if the distances exceeds the fence capacity for dead straight cuts. We recommend using the HP-10 Guide Fence when your cuts are less than 3" from the edge of your stock. If you have a need for a "V" groove that exceeds the capacity of the fence system you will need to clamp a guide in place. The side of the HP-10 body will ride against this reference and your cuts will be as straight as your reference edge.

To sharpen any of the irons, all you need to do is hone the bevel surface at 30 degrees, no special hones required.

There are two ways to control depth of cut, one can use the HP-10 Depth Skids (that came with your HP-10 Dado Kit "Works) or by fastening shims to the sole (using double stick tape).

Customer Reviews

Read Reviews | Write a review